How do I get back filtered data using 'filter' after after getting the digital filter from bandpass?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Ikmal Rosli
el 11 de Jun. de 2021
Hello everyone, I'm trying to figure out the bandpass and filter function, which I am using to filter out signals in the range of 1.9 to 4.1 from my data. My code below is based on the documentation. Basically, after getting the digital filter, d, from bandpass(), I tried using filter to get back the filtered signals, but I cannot seem to get the same output as from when using bandpass. Thank you in advance!
load data
fs = 24;
figure
bandpass(data,[1.9 4.1],fs)
[~, d] = bandpass(data,[1.9 4.1],fs);
figure
plot(filter(d, data))
[~, d] = bandpass(x,[100 200],fs);
figure
plot(filter(d, data))
0 comentarios
Respuesta aceptada
Chunru
el 11 de Jun. de 2021
Editada: Chunru
el 11 de Jun. de 2021
% load data
data = randn(512, 1);
fs = 24;
figure
% design filter, filter the data, plot the results
bandpass(data,[1.9 4.1],fs)
% desing the filter only
[~, d] = bandpass(data,[1.9 4.1],fs);
% filter the data using the filter object. (bandpass use filtfilt
% internally by default)
xf = filtfilt(d, data);
% compare the origninal and the filtered signal
t =(0:length(data)-1)/fs;
figure
plot(t, data, 'b', t, xf, 'r');
legend('Original', 'Filtered');
2 comentarios
Más respuestas (0)
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!