Why does the C24x PWM block's documentation refers to the "Pulse Width" setting when it should refer to the "Duty Cycle" setting in Embedded Target for TI C2000?
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
In the C24x PWM block's documentation page the term "Pulse Width" should be replaced by "Duty Cycle".
Respuesta aceptada
MathWorks Support Team
el 27 de Jun. de 2009
This is an error within the documentation for Embedded Target for TI C2000 within the C24x PWM block's section.
The documentation should read as follows:
The value set in Duty Cycle above determines the value in the register.
0 comentarios
Más respuestas (0)
Comunidades de usuarios
Más respuestas en Power Electronics Control
Ver también
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!