Community Profile

photo

A


Last seen: 7 días ago Active since 2021

Statistics

  • Thankful Level 2

View badges

Content Feed

View by

Question


Design method for elastic materials
I would like to design a model like the one in the attached figure.(1) is initial state, (2) is after deformation. ・The yellow ...

alrededor de 1 mes ago | 1 answer | 0

1

answer

Question


Simulink block to get the specified value
Is there a block that can get the initial value or specified value from the signal? If there is a way to find the value from a ...

alrededor de 2 meses ago | 2 answers | 0

2

answers

Question


How to use set_param correctly in a function
When I execute the following program in a function, each process can be performed, but the data in the To workspace is not refle...

alrededor de 2 meses ago | 1 answer | 0

1

answer

Question


How to write To Workspace data to a workspace
I want to be able to run Simulink from a program, write To Workspace data to the workspace in real time, and use the workspace v...

alrededor de 2 meses ago | 0 answers | 0

0

answers

Question


How to use timer and To Workspace
I want to run Simulink, use To Workspace to get data, and then use the values in the data to compute and find a value. However,...

alrededor de 2 meses ago | 0 answers | 0

0

answers

Question


About the use of find
I want to detect values greater than 10 and get their indices. In my case, I'm using find to get the index as follows. y = fin...

2 meses ago | 1 answer | 0

1

answer

Question


How to compound a block
I would like to use Variable Cylindrical Solid and Solid to create a block with a hemisphere at the end of the cylinder as shown...

3 meses ago | 1 answer | 0

1

answer

Question


How to change File Solid
I imported a CAD model into MATLAB Simscape. I was then able to generate the model in Simscape. What I am going to do is as f...

4 meses ago | 1 answer | 0

1

answer

Question


Adding contact blocks to a model imported from Inventer into Simscape
I have imported an Inventer CAD model into simscape multibody and added contact blocks to the model, but the contact simulation ...

6 meses ago | 1 answer | 0

1

answer

Question


単純なリンクのモデル化
Model a Simple Linkを参考にリンクを作成しているのですが,最後のカスタムブロックの保存方法がわかりません. カスタム ブロックのデザインと作成のどこを参考にすればカスタムブロックを作成できるでしょうか.

7 meses ago | 0 answers | 0

0

answers

Question


CADモデルを変更し,Simscape Multibodyにも反映するには?
Export an Autodesk Inventor Robot Assembly Model,Import a Robotic Arm CAD Model を見て,InventorのAssembly(CAD)からSimscape Multibody ...

8 meses ago | 1 answer | 0

1

answer