photo

Nandhini


Last seen: 5 meses hace |  Con actividad desde 2023

Followers: 0   Following: 0

Estadística

  • Thankful Level 2
  • Explorer

Ver insignias

Feeds

Ver por

Pregunta


Edit poles and zeros in root locus design editor or bode editor
While i am trying to get the bode plot for my input and output from my simulink model i am getting the error as mentioned below ...

6 meses hace | 1 respuesta | 0

1

respuesta

Pregunta


Scaling of generated duty cycle from simulink to NXP MCU expresso environment
I have developed the FOC model for PMSM, the generated code has been integrated with driver code in NXP MCU expresso environment...

10 meses hace | 1 respuesta | 0

1

respuesta

Pregunta


Angle estimation from hall sensor using hall decoder block
While i am trying to find the angle from hall sensor signal using hall validity block and hall decoder block, the angle varies o...

11 meses hace | 1 respuesta | 0

1

respuesta

Pregunta


Error: Integrating the generating code from embedded coder in renesas cubesuite(CS+) environment
Hi, I developed the FOC alogorithm in simulink environment and i generated the embedded code for renesas rl 78, when iam trying...

alrededor de 1 año hace | 1 respuesta | 0

1

respuesta

Pregunta


Issue when running the motor from open loop host model - Used custom hardware (Open-Loop Control and ADC Offset Calibration)
Open-Loop Control and ADC Offset Calibration using this link i generated the code from the model for STM32 Nucleo F302R8 bull ru...

alrededor de 1 año hace | 0 respuestas | 0

0

respuestas

Respondida
Code generation from Simulink to STM32F103 Processor.
Hi,thank you for the support.I tried implementing the open loop model, i generated the code and also integrated it with driver c...

alrededor de 1 año hace | 0

Pregunta


Code generation from Simulink to STM32F103 Processor.
I developed a model in simulink for BLDC motor with trapezoidal commutation with PI based speed and current control,I want to co...

alrededor de 1 año hace | 2 respuestas | 0

2

respuestas

Pregunta


If else condition is not working properly in matlab function block
function [y1,y2]= fcn(u1,u2,u3,u4) if u1 > 5 y1=u2; else y1=u3; end if u1 < 5 y2=u3; else y2=u2; end I implem...

alrededor de 1 año hace | 1 respuesta | 0

1

respuesta