Shengnan Li
Franklin Electric
Followers: 0 Following: 0
Estadística
CLASIFICACIÓN
266.916
of 292.710
REPUTACIÓN
0
CONTRIBUCIONES
7 Preguntas
1 Respuesta
ACEPTACIÓN DE RESPUESTAS
28.57%
VOTOS RECIBIDOS
0
CLASIFICACIÓN
of 19.933
REPUTACIÓN
N/A
EVALUACIÓN MEDIA
0.00
CONTRIBUCIONES
0 Archivos
DESCARGAS
0
ALL TIME DESCARGAS
0
CLASIFICACIÓN
of 147.871
CONTRIBUCIONES
0 Problemas
0 Soluciones
PUNTUACIÓN
0
NÚMERO DE INSIGNIAS
0
CONTRIBUCIONES
0 Publicaciones
CONTRIBUCIONES
0 Público Canales
EVALUACIÓN MEDIA
CONTRIBUCIONES
0 Temas destacados
MEDIA DE ME GUSTA
Feeds
Pregunta
Can someone provide a peak current mode controlled buck or boost circuit model in simulink?
Does anyone have a peak current mode controlled buck or boost or other power circuit model?Save me some time. Thanks a lot.
alrededor de 3 años hace | 0 respuestas | 0
0
respuestasPregunta
how to control Ball valve input signal s
The ball valve model has an input signal s to control ball displacement. I don't understand how it is controlled. for example, i...
más de 7 años hace | 1 respuesta | 0
1
respuestaPregunta
signal input of orifice/valve
How to specify this input? Thanks,
casi 8 años hace | 0 respuestas | 0
0
respuestasPregunta
Why signal changes rise/fall time outside the subsystem block?
I have a subsystem that has a direct look up table in it. the output of this look up table is the upper one in the attached fig....
alrededor de 8 años hace | 0 respuestas | 0
0
respuestas'to workspace' data length question
Thanks for answering my question. I finally figured out, it is the 'decimation' parameter. It was set to 5. when i changed to 1,...
alrededor de 8 años hace | 0
| aceptada
Pregunta
'to workspace' data length question
I specified the sample time for 'to workspace' block to be 10^(-5), but it saved only 20k data points, while it should be 100k d...
alrededor de 8 años hace | 2 respuestas | 0
2
respuestasPregunta
how to get the average frequency for the hysteresis band control?
I am simulating a Direct torque control induction motor. Want to know the average frequency. How do i get it from the switching...
alrededor de 8 años hace | 1 respuesta | 0
1
respuestaPregunta
Why I get different data from 'to workspace' and 'scope'
I have a switching signal, and a 'edge detector', try to count the pulses. The results from scope looks very good, the 'edge det...
alrededor de 8 años hace | 1 respuesta | 0