- add a unit delay block to your model
- feed the output of your EML block to the input of the unit delay and from the unit delay to the EML block
- remove the loop "for i=1:k" from your MATLAB code
Embedded Matlab Function - Output for every calculation
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Sheetansh Kaushik
el 25 de Jun. de 2014
Comentada: Sheetansh Kaushik
el 26 de Jun. de 2014
Good day to all!
I have some simple code:
function Pr = fcn(unused)
%#eml
k = 100;
Pr = 180;
for i = 1:k
x = Pr * 0.05;
y = Pr - x;
Pr = y;
Pr;
if (Pr == 0 || Pr < 0)
Pr = 180;
end
end
Intention here is simple: Decrease the value of Pr until equal to or less than zero and reset. Concurrently, see the rise and fall of the same on scope. But all i get is a single constant output(as shown in the pic).
WHERE AM I GOING WRONG?
Please let me know!
0 comentarios
Respuesta aceptada
Titus Edelhofer
el 25 de Jun. de 2014
Hi,
I think there is a misunderstanding of how this works. The MATLAB code you write is executed at each time step, completely. Since it does not depend on the input, it will give the same result each time (i.e. in each time step) where it is called ...
You could do the following:
Titus
3 comentarios
Titus Edelhofer
el 25 de Jun. de 2014
Your welcome. Feel free to mark the question as answered then ...
Más respuestas (0)
Ver también
Categorías
Más información sobre String en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!