Model simulink block connection with different simscape
Mostrar comentarios más antiguos
I am trying to connect a converter model to a grid model. The problem is the grid model was created in old matlab version by using PowerSimSystem. The pictures show how it does not allow me to connect the switch (out side the subsystem) to the current sensor(inside subsystem). Is there any solution for this situation? Any suggestion for another blocks that I could use instead or with my model.


2 comentarios
SALAH alatai
el 18 de Ag. de 2021
Because the blue line one and the black one from different library can't connect them together, try to find the same block from same library.
Rawaa Almajeez
el 18 de Ag. de 2021
Respuesta aceptada
Más respuestas (1)
Dr. Pemendra Kumar Pardhi
el 18 de Ag. de 2021
1 voto
Dear You can connect single phase voltage source from simelectrical-specialized technology- source. In between port 1 and 2 as shon your figure
3 comentarios
Rawaa Almajeez
el 18 de Ag. de 2021
Dr. Pemendra Kumar Pardhi
el 18 de Ag. de 2021
Dear Rawaa Almajeez
I have upload the model on Mathwork for grid connected single phase PV system.
here i have used single phase source as a utility grid, you can downolad it via given linke below
Rawaa Almajeez
el 18 de Ag. de 2021
Comunidades de usuarios
Más respuestas en Power Electronics Control
Categorías
Más información sobre Get Started with Simscape Electrical en Centro de ayuda y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!