How do end a task on Zynq when using "Build, Deploy and& Start"?

1 visualización (últimos 30 días)
丹 姚
丹 姚 el 26 de Sept. de 2021
Hello all,
I uses Matlab 2020b and Xilinx Zynq UltraScale+ MPSoC ZCU102 evaluation kit for model based development.
I found that when I building ARM executable, "Monitor &Tune" will start a task that follows my "Stop Time", but when I use "Build, Deploy and& Start", the task will not stop until I powered off my Zynq board.
So how to build a task with stop time on Zynq when using "Build, Deploy and& Start"?
Thanks a lot

Iniciar sesión para responder a esta pregunta.

Respuestas (0)

Categorías

Más información sobre Targeting FPGA & SoC Hardware en Help Center y File Exchange.

Etiquetas

Productos


Versión

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by