Error when using connection labels

Hi everyone,

I have a very simple model just to test the functionalities of the Connection Label block. I connected the model in the way shown in the following Figure:

However, when I try to run it, I get the following error: "The connection attached to the Connection Label block 'Connection_Label/Connection Label' is not supported."

Can somebody help me?

Thank you very much in advance,

José Miguel Riquelme

[Electrification Enthusiasts]

Hello Jose,

unfortunately, the connection label doesn't work with specialized power systems models. You would need to use the core simscape components (blue and light blue) to take advantage of the connection label block.

Joel

Answer 1

[Joel Van Sickel]

pasting the above answer here so the quesiton shows up as being answered:

unfortunately, the connection label doesn't work with specialized power systems models. You would need to use the core simscape components (blue and light blue) to take advantage of the connection label block.

-Joel