How to make correct axis?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Im doing a plot using surfc(z(2:74,2:20)) (2:74 and 2:20 because the first row and first column is the x- and y-axis values), but.. my data is from a simulation where i used 5 steps between each simulation. So my x-axis goes from 0 to 90, but with only 19 values. Same problem with the y-axis - there i have 73 values, but going from -180 to 180.
How do i make matlab understand this, so that the values on the x- and y-axis isnt 0-20 and 0-80 ?
Thanks in advance - i hope there are some bright minds out there :)
0 comentarios
Respuestas (1)
Jan
el 13 de Sept. de 2011
You have to define the X- and Y-values in the SURFC command to define the X- and Y-values in the plot. E.g.:
[X,Y,Z] = peaks(30);
figure
surfc(X,Y,Z)
figure
surfc(X + 10,Y,Z)
Ver también
Categorías
Más información sobre 2-D and 3-D Plots en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!