Programatically configure arduino in standalone application
5 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
David Wilby
el 17 de Nov. de 2021
Editada: David Wilby
el 6 de En. de 2022
Hi,
In a standalone application which uses the Arduino Hardware Support Package, on connecting to the arduino, the "Configure Arduino" dialog is launched, asking the user to specify port, board and path to the ardunio IDE.
Is there a way to programmatically bypass this manual config step?
Thanks
0 comentarios
Respuesta aceptada
Kshitij Chhabra
el 27 de Dic. de 2021
Hi,
For a clean installation, the IDE Path should be automatically configured when you install the Arduino Support Package. You can check the following MATLAB Answer to debug probable causes.
Additionally, the path can be set by the following command
arduinoio.IDERoot = 'Link To Path'
Hope it helps!
1 comentario
Más respuestas (0)
Ver también
Categorías
Más información sobre Arduino Hardware en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!