FOC Control Motor Control Blockset
3 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hello,
I'm using mcb_param_est_host_read.slx to get the parameters of my PMSM motor.
However in the application shaft is tied to proppeler.
My question - when measuring motor params with mcb_param_est_host_read.slx should I have proppeler tied to the motor or measure the motor alone? Because for sure inertia and probably max torque measurements will be different with and without proppeler.
I'm asking in terms of using these parameters in mcb_pmsm_foc_sensorless_f28379d.
Thanks,
Adam
0 comentarios
Respuestas (2)
Shang-Chuan Lee
el 1 de Mzo. de 2022
Hi Adam,
The motor parameter estimtion of this demo mcb_param_est_host_read is based on no-load condition on the PMSM, so it is recommend to measure motor parameter alone. This link below explains the prerequistic and steps to run this test.
Regards,
Shang-Chuan
0 comentarios
Ver también
Categorías
Más información sobre C2000 Microcontroller Blockset en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!