Info
La pregunta está cerrada. Vuélvala a abrir para editarla o responderla.
Using Ideal Switch in Simpower Systems
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hello, I tried using the "ideal Switch" block in Simpowersystems. I conneceted it to a battery I coded a matlab function block with if commands to give instructions to the switch via the gate(which is a simulink in put signal) to toggel between off and on. But it does not work.
so see what I did.
in the matlab function block
i did if command as follows,
if u==1 y=0; else y=1; end
but when i pass "1" through it still outputs the voltage in the battery. I have the voltage measurement between the switch and the negative port of the battery. so I have a display attached to the voltage measurement.
Please assist me with this issue.
thanks.
0 comentarios
Respuestas (0)
La pregunta está cerrada.
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!