PCI-6229 not recognised by Matlab R2011b
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi
I was using the PCI-6229 NI card for analogue and digital IO in combination with Matlab R2007b this was working fine. Then I wanted to use also the counters available at the PCI-card. I found out that this was not possible in R2007b, but it would be possible in R2011b. So I installed the new Matlab version. Then I found out that I needed new NI-DAQmx software too. So I installed the new NI-DAQmx software (version 9.2.3).
However when I now run: >> info=daqhwinfo('nidaq')
info =
AdaptorDllName: [1x68 char]
AdaptorDllVersion: '3.0 (R2011b)'
AdaptorName: 'nidaq'
BoardNames: {1x0 cell}
InstalledBoardIds: {1x0 cell}
ObjectConstructorName: {0x3 cell}
>> info.BoardNames
ans =
Empty cell array: 1-by-0
My PCI-card isn't found.
What should I do?
0 comentarios
Respuesta aceptada
Rob Purser
el 29 de Sept. de 2011
Can you see your device in NI Measurement and Automation Explorer? Until you see it there, it can't show up in MATLAB.
To use the counter/timer support, you'll need to use the new Session based interface. You may want to port your analoginput code over as well. There's several examples/demos showing the new counter/timer support
-Rob
Más respuestas (1)
Teresa
el 8 de Nov. de 2011
Hi,
I am having a problem accessing my DAQ Card (NI PCI 6229) with matlab 2007b. I also, updated my driver software. Wondering if you tried to run matlab 2007b on your card with the updated software and if it worked? Note I am using windows 7.
Thanks,
Teresa
Ver también
Categorías
Más información sobre Data Acquisition Toolbox Supported Hardware en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!