Generating code for simple model taking too much time in simulink

I am trying to generate simple blinking led code for NXP 32K1XXX and it is taking over an hour to generate code in fact it should just take a few min in max.

There is no error message or something.

I even checked all the settings to make sure its generating code for my specific Micro Controller.

Answer 1

[Tushar]

Hi Jasmeet,

I understand that you are experiencing longer code generation times with the Embedded Coder for a simple model. Since there are no error or warning messages, I recommend exploring the following resources to troubleshoot the issue:

1. NXP Support Package S32K1xx on File Exchange - This resource, created by the NXP Model-Based Design Toolbox Team, may provide insights and solutions related to your specific NXP platform.
2. Similar question on MATLAB Answers - There is a chance that someone has encountered a similar issue before. Pay attention to the comment by Mark McBroom, as it may contain helpful steps to follow.
3. Contact MathWorks Support - If the issue persists, you can try reaching out to MathWorks Support. They may be able to provide additional assistance and guidance specific to your situation.

I hope these resources help you debug the issue and improve the code generation time for your model.