error when using command "quiver"

trying to plot zonal and meridional wind data via the "quiver" command and I get the following error:

Error when using quiver (line 58) The size of X must match the size of U or the number of columns of U.

The data I used is attached (.mat) on google drive, it has 90mb, so I didn't put it here. follow the link: https://drive.google.com/open?id=18GgPs-iN3brZHQ3pZNK8GyLt4SOmemY8&authuser=costapereira620%40gmail.com&usp=drive_fs

Anyone a solution??

% load 'dat_era5_201007.mat' 

%%
t1 = datetime(2007,07,1,0,0,0); % 01/jul/2007 as 00h
t2 = datetime(2007,07,31,23,0,0); % 31/jul/2007 as 23h
t = t1:hours(1):t2; % sera gerado datas no intervalo de t1 a t2
%%
cd 'H:\DADOS_SCi-MSc\DadosEra5PreComp'

data1 = load('dat_era5_201007.mat', 'u10');
data3 = load('dat_era5_201007.mat', 'v10');

u10=data1.u10;
v10=data3.v10;

u10=u10(:,:,t==t);
v10=v10(:,:,t==t);

u10mean=mean(u10,3);
v10mean=mean(v10,3);

load('dat_era5_201007.mat', 'lon');
load('dat_era5_201007.mat', 'lat');

%%
figure
[x, y]=meshgrid(lon(:,1),lat(:,1));
quiver(x,y,u10mean,v10mean)

Answer 1

[Augusto Gabriel da Costa Pereira]

if you perform the following tweak it will work fine

figure
imagesc(lon(:,1),lat(:,1),v10mean)
[x, y]=meshgrid(lon(:,1),lat(:,1))

hold on
h=quiver(x,y,u10mean',v10mean','w')

Answer 2

[Cris LaPierre]

You have created x and y so that they are 53x57 arrays, but u10mean and v10mean are 57x53. As the error message says, they must be the match.

Try this instead.

[x, y]=meshgrid(lat(:,1),lon(:,1));
quiver(x,y,u10mean,v10mean)