build an augmented PID control model for a DC servo motor in Simulink

Hi there,
I am going to build an augmented PID control model for a DC servo motor in Simulink.
The state-space model of the DC motor has been built already.
Here I want to find a way to realise the augmented PID control, with the block of PID in simulink.
Are there any ways to realise it?
Many THX!

5 comentarios

Have you manually designed the PID already?
What is the DC motor state-space model?
What is desired response time of the motor?
Hi Sam, thx for your interest.
we try to use the pid block in the control toolbox to save time, but we are not sure whether the block can realise the augmented pid or not. The state space model of a dc motor can be found in the control toolbox user'guide (the pdf file is on the mathworks website). we are now not concerning too much about the performance, but try to build the model first.
many thx!
Thanks for your reply, @Tony Cheng. What does the augmented PID controller do?
Hi Sam, I want to control the speed of the motor using this comtroller.
Sam Chak
Sam Chak el 13 de Abr. de 2023
Editada: Sam Chak el 13 de Abr. de 2023
I think the ordinary PID block can also control the speed of the motor. For the augmented PID, do you mean to "group" the PID block and the Motor block together under a single Block Mask?
I have also searched online and found these two configs. Which one are you referring to?
Config #1
Efe, M. O. (2015). An augmented PID control scheme for robust control. 2015 International Workshop on Recent Advances in Sliding Modes (RASM). https://doi.org/10.1109/rasm.2015.7154582
Config #2
di Capaci, R. B., & Scali, C. (2018). An augmented PID control structure to compensate for valve stiction. IFAC-PapersOnLine, 51(4), 799–804. https://doi.org/10.1016/j.ifacol.2018.06.181

Iniciar sesión para comentar.

 Respuesta aceptada

Sam Chak
Sam Chak el 15 de Abr. de 2023
Editada: Sam Chak el 15 de Abr. de 2023
I'm unfamiliar with your system, but the Augmented PID Control Scheme should look like the following diagram in Simulink. If the model reference is a linear system, then the S-function can be replaced by a State-Space block.

2 comentarios

Sam, thanks so much! I think this diagram is what I want. I will try to realise it in simulink.
You are welcome, @Tony Cheng. The S-Function block is preferred because it can send the acceleration output directly in this section of the code.
function sys = mdlOutputs(t, x, u)
sys(1) = ... % xd
sys(2) = ... % xd'
sys(3) = ... % xd''
end
However, the block requires a bit of programming skill. If you are familiar with ode45(), then I think you should be okay with it.

Iniciar sesión para comentar.

Más respuestas (1)

Tony Cheng
Tony Cheng el 13 de Abr. de 2023

Hi Sam, thx for providing the 2 choices. the term augmented means the actuating torques of a motor for a predefined trajectory are feedforwarded into the pid controller. if u can find the paper

and fig.4 in this paper, u can easily get the meaning.

Cheers Chen

Preguntada:

el 12 de Abr. de 2023

Comentada:

el 15 de Abr. de 2023

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by