Is 'Arduino Nano 33 BLE Sense Rev2' hardware board compatible with Simulink?

Is 'Arduino Nano 33 BLE Sense Rev2' hardware board compatible with Simulink? I tried a Simulink demo model (simple on off the inbuilt led on the Arduino Nano 33 BLE Sense Rev2 hardware board) to verify my board connection with Simulink and I found the following error message in the Simulink Doagnostic Viewer.

Caused by:

• Failed to detect host COM port of Nano 33 BLE board.
• Install or update the Arduino board driver and try again.

Answer 1

[Nathan Hardenberg]

Maybe you can check the steps provided in this thread: https://de.mathworks.com/matlabcentral/answers/1603060-can-not-connect-hardware-arduino-nano-33-ble-sense-bootloader-com-port-error

[Siva Teja Avanigadda]

I tried that, but it wasn't working.

[Yujiang Wu]

Hi,

Have you figure out a solution? I am facing the same issue. Thanks.

Best regards,

Yujiang

Answer 2

[Angelo Yeo]

Can your computer detect the board in a COM port?

One thing to check is your USB cable. Are you sure you are using a data USB cable not a charging only USB cable? Usually, data USB cables have its mark on it.