in My model I am using torque controller with FOC for IPMSM. How to tune Current Controller PID .Because Current controller have two PID controller.
3 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
adhavan d
el 26 de Jun. de 2023
Respondida: Darshan Pandit
el 26 de Jun. de 2023
In my model ,Torque controller with FOC is used for IPMSM .FOC has current controller.Current controller have two PID controller.I don't know how to tune two PID at same time.Now torque results have overshoot and under shoot ,and actual torque graph result have delta with request torque(10%).thats why machine speed have delta with request speed.Totque results bandwith have 200%.So.I have to rectify all isuue.So,Please give proper procedure for current controller PID tuning for Torque controller concept for IPMSM.
additional Question:does torque control method have PID block?
0 comentarios
Respuesta aceptada
Darshan Pandit
el 26 de Jun. de 2023
Hi adhavan,
there are more than one ways to tune the PID controller. It depends on many factors such as motor parameters, switching frequency, control sample time, sensor gains, etc.
following page may be a good start.
https://in.mathworks.com/help/mcb/gs/estimate-control-gains-from-motor-parameters.html
0 comentarios
Más respuestas (1)
Mohamad Nazir
el 26 de Jun. de 2023
You can follow the steps of the following example in the link below to tune the current controllers at first and then repeat it for the torque controller if necessary.
https://www.mathworks.com/help/slcontrol/ug/tune-field-oriented-controllers-using-closed-loop-pid-autotuner-block.html
0 comentarios
Comunidades de usuarios
Más respuestas en Power Electronics Control
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!