How to get ESP32 as an option for board when setting up hardware setup

Hi i am follow this link to connect ESP32 to matlab

https://au.mathworks.com/help/supportpkg/arduinoio/ug/configure-setup-for-esp32-hardware.html (MATLAB Support Package for Arduino Hardware)

However when I follow instructions i do not get the options of ESP32. How do i make it so that i can?

Answer 1

[Jongil Lee]

Hi Jordan

Please check your MATLAB/Simulink version using "ver" command.

ESP32 board supports from MATLAB R22a. Please refer to check link.

[Jordan Hill]

Hi Jongil,

Thank you so much. I was running a 2021 version so it wasnt working. However we have a ESP32-S3-WROOM-2, is there anyway that board is supported or can we not connect to that one?

Kind regards,

Jordan

[Mike]

I have the same Question. Can i change the config to suport ESP32-S3?

[Alex Winkler]

Same here... ESP32-S3 wroom-2 devkit C1.

[Darnel]

Do you have any solution for esp32 s3?

[MathWorks MATLAB Hardware Team]

For the latest details on ESP32‑S3 boards compatibility with MATLAB Support Package for Arduino Hardware, Refer to the MATLAB Prerelease hardware support documentation, which provides the most up‑to‑date information on supported boards.

Thanks,

MATLAB Hardware Support team