- Review and Adjust Model Inputs: The error is likely due to the model struggling to reconcile conflicting initial conditions. Ensure that the initial conditions are consistent and do not conflict with each other.
- Standardize Signal Units: Verify that the signal units used throughout the model are uniform. Inconsistent units can lead to calculation errors and model instability.
location information is protected
3 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Warning:At time 0.000000e+00, one or more assertions are triggered. State of charge must be greater than or equal to zero. The assertion comes from:
Block path: hope17/Subsystem2/Subsystem/B1/Battery (Table-Based)
Assert location:
o (location information is protected)
How to resolve this error?
0 comentarios
Respuestas (2)
Dhruv
el 20 de Sept. de 2023
The error message provided indicates that there is an assertion error related to the State of Charge (SOC) of a battery in the simulation.
The assertion error is triggered because the State of Charge must be greater than or equal to zero, but at time 0.000000e+00, it appears that the SOC value is not meeting this requirement.
To resolve this error, follow these steps:
Hopefully, by implementing these steps, you should be able to resolve the issue!
0 comentarios
Dhanashri
el 1 de Oct. de 2024
At time 0.000000e+00, one or more assertions.Voltage versus state of charge equations coefficient,beta is not in an acceptable range.Setting to 0.The assertion comes from: battery Assrt location 0( location information is protected) Then now what can i do??
0 comentarios
Ver también
Categorías
Más información sobre Battery Pack Modeling en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!