Mutual Inductance block tunable parameter not updating during simulation

Updating the tunable parameter (Inductance Matrix (2x2) with 2 windings selected) of the Mutual Inductance block (drop down Generalized Inductance selected) does not cause any chage in a scope via voltage/current measurement blocks or by selecting voltage/current measurement within the block then using the multimeter and a scope. Ive updated the parameter via "set_param" as well as manually while the simulation is running. Ive also paused and updated (Ctrl+D), but no visible changes. The only time the tunable parameter change takes affect is if the simulation is completely stopped then started.

[Sulaymon Eshkabilov]

Can you share your model? So we can take a look at it.

[mark hoffman]

Attached is the .slx file and the .mlx file that generates the values