PIL simulation with matlab 2019b

Hi,

my F28335 board is well configured with Matlab 2019b, CCS12.8 and controlsuit. The implementation works perfectly. However, I encounter a small problem with PIL simulation, receiving the error bellow.

Has anyone encountered a similar issue or has any suggestions on how to resolve this? Any help would be greatly appreciated!

Thanks in advance!

------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

The timeout of 10 seconds for receiving data from the rtiostream interface has been exceeded. There might be multiple reasons for this failure.

You should:(a) Check that the target hardware configuration is correct, for example, check that the byte ordering is correct.

(b) Confirm that the target is running.

(c) Consider the possibility of application run-time failures (e.g. divide by zero exceptions, incorrect custom code integration, etc.).

Note (c): To identify possible reasons for the run-time failure, consider using SIL, which supports signal handlers and debugging.

Answer 1

[Vandit]

Hello Zorig,

It seems that the error message you're encountering may be related to the settings in the hardware configuration. Please ensure that you have selected the correct SCI pins and have verified the baud rate.

Additionally, you might find it helpful to refer to this MATLAB Answers thread, which discusses a similar issue:

https://www.mathworks.com/matlabcentral/answers/409838-issue-in-running-pil-with-ti-c2000

Hope this helps.