I cannot flip manual switch while in monitor and tune

Hello,

When running a simulation on an Arduino Mega 2560 through monitor and tune, I cannot change the position of any manual switch in my block diagram. I am running the simulation on the board and the sim is running on external mode through XCP on Serial. Any help would be much appreciated.

[Abhinav Aravindan]

Hi @Malek,

Could you share the Simulink model file to understand the issue better?

[Malek]

Hello @Abhinav Aravindan,

Attached is my simulink file.

Answer 1

[Amal Raj]

Hi Malek, I think you are faced with a bug in 2024b.

The workaround would be to update Default Parameter Behavior parameter drop-down value to Tunable in the config set.

This will solve the issue you are facing. You can even try working with other versions of MATLAB, and you should be fine.

Regards,

Amal

[Vorrapath Kokaew]

So, do I. I use ESP32 with arduino package that message shown Cannot change the model '.......' while the simulation is running. Anyway, I already follow the Amal Raj suggestion that WORK!!!!

Thank a lot