Hi, I tried to use fmincon but I received the message. How I can overcome this problem?
59 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Muna Shehan
el 24 de Mayo de 2015
Editada: Walter Roberson
el 28 de Jun. de 2015
" fmincon stopped because the size of the current step is less than the default value of the step size tolerance but constraints are not satisfied to within the default value of the constraint tolerance "
0 comentarios
Respuesta aceptada
Más respuestas (2)
Mark Stone
el 25 de Mayo de 2015
Editada: Mark Stone
el 25 de Mayo de 2015
If you provide reproducible code, i.e., all input data, options, etc., perhaps someone can offer more concrete help.
As has been previously suggested, poor scaling may be at least part of your problem. But another possibility is that you are using incorrect derivatives (gradient of constraint and maybe objective function). Are you supplying gradients, or is it using numerical differentiation? Have you used the derivative check option (actually, I'm not sure that checks constraint gradient, though).
It may also be the case that you can succeed from a different starting point. In general, you may have better luck with tricky constraints if you use the active-set, or maybe better yet, SQP algorithm than the other algorithms.
Can you show the output using iter-detailed?
1 comentario
Muna Shehan
el 28 de Jun. de 2015
Editada: Walter Roberson
el 28 de Jun. de 2015
Muna Shehan
el 25 de Mayo de 2015
1 comentario
Walter Roberson
el 25 de Mayo de 2015
Note that when you recenter and rescale that you will need to adjust your constraints and you may need to adjust your function.
There are a lot of cases that recentering and rescaling will not fix, and a different approach is needed.
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!