extractFeatures, reference to "Block"-method
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hi
I'm compairing the SURF- and the Block-method in the extractFeatures-function.
Is there any article which describes the Block-method which the Matlab implementation is built upon? Is it the same implementation as the "Block-matching method" in OpenCV? I can't find much (if any) information in the book "Learning OpenCV" which is referred to in the documentation.
0 comentarios
Respuestas (1)
Alex Taylor
el 29 de Dic. de 2011
I'm not sure about where to find a good reference at the moment, if you're looking for a paper, but if you look in the reference page for extractFeatures:
The description of block is:
"Simple square neighbhorhood. Note: The Block method extracts only the neighborhoods fully contained within the image boundary. Therefore, the output, VALID_POINTS may contain fewer points than the input POINTS."
In the example that is provided:
I = imread('pout.tif');
hcornerdet = vision.CornerDetector;
points = step(hcornerdet, I);
[features, valid_points] = extractFeatures(I, points);
They are using the default 'auto' method, which will use the 'block' method because the input points are Nx2 coordinates from the corner detector.
Block feature extraction just extracts small neighborhood blocks of the actual image data centered at the [X Y] locations specified in the point input. In this case, the extracted features blocks of the input image 'pout.tif' centered at corner locations.
Hope that helps.
Ver también
Categorías
Más información sobre Computer Vision with Simulink en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!