TI DSP 28377D HOW TO RUN A MODEL

Hi

I have created the attached model to run on a texas Instruments DSP DELFINO 28377D.

Do you know how to run the generated code on the DSP??? Do I need to use code composer?? I Have clicked on Deploy to hardware on Simulink and this is the answer I get,

however I don't know how to proceed and run the code on Code Composer 6. I also attach my simulink model.

Please help,

Thanks

Leo

Answer 1

[Michael]

Hi there,

are there any new on this topic? Have exactly the same problem. Connection with CCS works fine, but not with Simulink.

Kind regards Michael

Answer 2

[Rohit Jain]

I think the below link would be useful for you:

http://in.mathworks.com/matlabcentral/answers/94824-how-do-i-run-my-code-in-the-flash-memory-of-ti-c2000-board-on-target-support-package-tc2-r2008a

Hope this helps.

[Lello]

Thanks for your answer. DO you know if these feature work with code composer version 6?

thank you

Answer 3

[Sumith Sekharan]

Hi Leo,

MATLAB is using CCS Debug Server to load code to the target hardware. From the error message, it looks like connection to the F2377D is failed. There are few things to verify:

1. Ensure you can connect to the board using CCS.
2. If you cannot connect using CCS, please try to update the CCS software to get F28377D support. You may be missing the hardware configuration files for F28377D processor.

Thanks,

Sumith

Answer 4

[Lello]

Hi Sumith,

thanks for your answer. I use CCS connected to the board and the communication (USB) works fine. MATLAB does not seem to work in this regards. Perhaps it does not support CCS version 6?

Regards

Leo

Answer 5

[Lello]

Dear Matlab,

Any answer in this regard?

Thanks

Leo