How do I connect a Joint spring-damper to a prismatic joint which is further connected to a mass in SimMechanics, without letting two masses disconnect.?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hello, I am trying to model a system that consisting of mass(which is in motion in x direction)- (spring &damper in x direction) - mass - (spring and damper in z direction) using simmechanics. While putting a joint spring and damper on a prismatic, it disconnects and the masses moves at separate velocity. Is this a normal situation ? I have been trying to fix things a lot. Now, suppose I use a revolute joint the masses stay connected, but not with the prismatic joint.
2 comentarios
Ari
el 30 de Jun. de 2017
Can you provide a rough sketch of how the massses and SMDs are connected along with which is the x and z directions?
Respuestas (1)
Steve Miller
el 3 de Abr. de 2019
Hi - without the model, it is very hard to give you a good suggestion.
Some things it could be:
- Springs were too weak, and gravity pulls them far apart.
- Your did not properly attach the mechanism to ground
If you share the model we may be able to give better advice.
--Steve
0 comentarios
Ver también
Categorías
Más información sobre Assembly en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!