how to move cursor on the floating scope

I have MATLAB R2016a. How do I easily get the data points for the particular time. I have plotted V1 vs. Time and I2 vs. time using simulink. I can't move cursors on the plots what can I do? I just need the data value for V1 and I2 for 40 micro sec time? Thanks

Answer 1

[Muhammad Adeen]

after accessing the Cursor Measurement panel in the Scope menu by selecting Tools > Measurements > Cursor Measurements. The cursor are frozen to a fixed point and are not movable. What should I do.

[Arjun Sridhar]

You should go out of zoom mode. To be able move the cursor.

Answer 2

[Michelle Wu]

It is my understanding that you generated signals in Simulink and would like to read data values from the Scope. If this is the case, you can access the Cursor Measurement panel in the Scope menu by selecting Tools > Measurements > Cursor Measurements.

[Muhammad Adeen]

after accessing the Cursor Measurement panel in the Scope menu by selecting Tools > Measurements > Cursor Measurements. The cursor are frozen to a fixed point and are not movable. What should I do.

[Jorge]

yes, but the question is about moving them....I have the same problem. I see the cursors, but cannot move them.

[Sam]

same problem here