how to find the corrupted data at Non volatile memory(NVM) in simulink?
12 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I haev block for NVM, uint16 is the size, presently I am limiting it using Saturation block, How to get,if the data is corrupted in that block?
0 comentarios
Respuestas (1)
Walter Roberson
el 3 de Oct. de 2016
For something like that you would normally use at least an error detection code (such as a CRC), and possibly an error correction code; http://www.springer.com/gp/book/9781402083907
2 comentarios
Walter Roberson
el 3 de Oct. de 2016
No. For NVRAM, corrupted data is data for which the write to NVRAM stored a different value that was requested to write, together with data which reads back from the NVRAM differently than what was previous written to that location. If you write a saturated value and the NVRAM reads back the saturated value when you eventually ask what is there, then the NVRAM is not corrupted.
An example of "corrupted data" is data written to a magnetic stripe card, when you bring the card too close to a strong magnetic field: it no longer has the original data stored in it.
Most NVRAM technologies have a (fairly high) rated number of read cycles, and a (much) lower rated number of write cycles, before the NVRAM or the stored data starts to wear out. See page 3-14 at http://www.semicon.panasonic.co.jp/en/aboutus/pdf/t04007be-3.pdf for some of the causes.
Ver también
Categorías
Más información sobre Large-Scale Modeling en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!