how to measure a FFT of 50Hz signal?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
hi
I want to measure the FFT of 50HZ signal. I collect the data from oscilloscope which is also attached herewith. the total sample points are 10000. I need the FFT in bar graph as like in attached picture ( mag (% of Fundamental) vs Harmonic Order )but I am unable to do this. kindly help me I will be highly thankful to you.
6 comentarios
Walter Roberson
el 28 de Nov. de 2016
Looking through the data, I can see that the times given are stored to only two digits after the decimal place, which is a problem because at the initial range the change is all in the third decimal place. You would be better off ignoring the times and re-synthesizing them knowing they are 1E-5 apart.
Walter Roberson
el 28 de Nov. de 2016
"but the sampling rate is 10KHZ"
Your timestamps do not make any sense unless the data points are 1E-5 apart, which corresponds to 100 kHz not to 10 kHz.
Respuestas (1)
Image Analyst
el 27 de Nov. de 2016
Did you use fft() or pwelch()? If not, why not? If you did, what did you do? Where is your code?
2 comentarios
Mudasir Ahmed
el 27 de Nov. de 2016
Editada: Walter Roberson
el 28 de Nov. de 2016
Walter Roberson
el 28 de Nov. de 2016
The graph uses 40 harmonics separated by 1/2 rather than 100 harmonics separated by 1.
Also as I indicated above, your sampling frequency is surely 100000 rather than 10000 .
Ver también
Categorías
Más información sobre Spectral Measurements en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!