MATLAB Answers

How to switch simulink blocks using a parameter?

1 view (last 30 days)
Martin
Martin on 18 Jan 2017
Commented: Martin on 26 Jan 2017
Hello,
in my Simulinkmodel I want to test different controller blocks. In my "Input Generation"-block I implemented 4 different controllers. Everytime I want to test another controller, I have to remove the input and output connections and make new connections for the new block by hand which is quite annyoing. Is there a way to to this with a parameter? Say if some constant c is equal to 1, I want Controller 1 to be connected to the input and output ports of "input generation" and so on. Thanks for your help.

  0 Comments

Sign in to comment.

Accepted Answer

Jordan Ross
Jordan Ross on 24 Jan 2017
Hello Martin,
What you are going to want to use is actually is a "variant subsystem". The following documentation page discusses what they are:
However, of more interest to you is the following documentation page which contains an example of modeling different variants of controllers:

  1 Comment

Martin
Martin on 26 Jan 2017
Thanks Jordan! This is, what I was looking for.

Sign in to comment.

More Answers (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by