Info

La pregunta está cerrada. Vuélvala a abrir para editarla o responderla.

How to change a block parameter using SimState?

1 visualización (últimos 30 días)
Daniel Silva
Daniel Silva el 5 de Abr. de 2017
Cerrada: Sabin el 23 de Dic. de 2024
Hello everybody.
I'm trying to simulate different types of faults in a Simulink electrical power system. Then, I'm using SimState to get the system steady-state and from this point I want to apply the faults and check the behavior.
Thus, I'm using the Three-Phase Fault block to apply the fault and I need to change the type of fault at this block after SimState is loaded but system consider that is an error. How can I fix it?

La pregunta está cerrada.

Respuestas (0)

La pregunta está cerrada.

Etiquetas

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by