Hi Cristiano,
I understand that you are running a simulation in External mode on Arduino through a Virtual Desktop interface, but you are encountering issues when you try to sample at over 200 Hz.
First, please note that MATLAB is not qualified against virtual desktops, and therefore, virtual desktop operations are not guaranteed to perform as expected.
If you are experiencing lagging data or missing data points, you may be able to correct this by changing the Duration parameter in your model's External mode settings.
The Duration value specifies the number of contiguous points of data to be collected in each buffer of data- this value should be large enough that the time it takes to send the data is less than the times it takes to log the next packet of data. If you enter a value less than the number of available sample points since the previous sent packet, you may lose sample points during the time spent transferring values from the data buffer to the MATLAB workspace.
To set this value, please use the following steps:
1. Under the 'Code' tab in the Simulink window, select 'External Mode Control Panel'.
2. Open the 'Signal and Triggering...' window.
3. Set the Duration parameter.
4. Click 'OK' to apply your changes and close the window.
By default, the Trigger duration for Arduino models is set to 2. To prevent loss of data, increase the duration to a value greater than 2 (For instance, for a sample time of 1 ms, set the Duration to 10).
For more details, please see the following documentation link:
