Question about the "enable" block.
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hi,
I have a little question about the enable block. If I have a enable block in a subsystem, what become my outputs when my subsystem is not enable ? And more specially when I have one output which is a bus ?
0 comentarios
Respuesta aceptada
Más respuestas (2)
Arnaud Miege
el 18 de Mzo. de 2011
Have a read of Enabled Subsystems in the Simulink documentation, particularly the section Setting Output Values While the Subsystem Is Disabled. As far as I know, this works with busses as well.
HTH,
Arnaud
0 comentarios
Sébastien Malengé
el 18 de Mzo. de 2011
2 comentarios
Guy Rouleau
el 22 de Mzo. de 2011
Did you really read the section mentioned by Kaustubha? This is what you need. Note that it is available since MATLAB R2010a.
Kaustubha Govind
el 23 de Mzo. de 2011
Guy: I think Sebastien's reply was to Arnaud's answer. My answer came later but got voted up, so it shows up higher.
Ver también
Categorías
Más información sobre Schedule Model Components en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!