simulink TI C2000 F28035 Data monitoring

Hello all,

I am trying to drive a PMSM motor with Ti HV KİT. I have Piccolo 28035.

I am deploying the example simulink block(PMSM FOC) to DSP but, I need to monitor real time data at my PC.

I configrated model parameters. Configuration Parameters > Hardware Implementation > Hardware board settings > Target hardware resources > External Mode and set the communication type (serial) and Serial port (COMX).

After all this settings ı dont know how to read data.

We have been scratching our head with this so any suggestions would be greatly appreciated.

Thanks again,

Mustafa

Answer 1

[Yash]

Hi Mustafa,

I understand that you are not able to connect to a suitable port for reading data. I suggest you to go to the host model and click on the data receive blocks, right click -> block parameter -> select the required port.

Hope this helps.