Variant control variable initialization
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
I have a variant subsystem where one of the controls is throttle_controller == 1.
My initFcn first clears the workspace, then runs a script where this variable throttle_controller gets initialized. If I run the stuff in the initFcn from the command line, this variable throttle_controller does show up so I know the initFcn works as intended.
When I run the simulation, I get an error
Variant control 'throttle_controller == 1' used by block 'Car/software/throttle_controller' should return a logical value.
Caused by:
- Undefined function or variable 'throttle_controller'.
Then I check the workspace, it is blank. Apparently the initFcn didn't even run yet. Does the variant subsystem look for its necessary variables before callbacks are run?
How do I initialize the variable in the initFcn? I don't want to put it in postLoadFcn because I change the value of the variable and run the model many times after I load it once.
0 comentarios
Respuestas (1)
Jesús Zambrano
el 6 de Feb. de 2020
Hi Cheyenne,
Try to use the PreLoadFcn callback, which is executed before the model is loaded. The variable will be in the workspace, then you can change it before running a new variant. Also check some workflow here https://se.mathworks.com/help/simulink/ug/create-and-open-models.html#btozflu-1
0 comentarios
Ver también
Categorías
Más información sobre Component-Based Modeling en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!