How to visualize Images and data with parrot mambo minidrone?
11 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hello
Am trying to do some image processing using parrot FPV Camera. I tried the model in "open_system('parrot_vision_ext_mode')" the code works but I couldn4t visualize what is happening. I saw This workarround here but it works just in matlab 2019a. How can I use blocks like To Video Display block!!! or even If I can't visualize how can I add results in mat.file generated in the GUI (below) that appears after the uploading of the code!!
please help
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/222555/image.png)
Respuestas (1)
Srijith Vijay
el 5 de Jun. de 2019
Editada: Srijith Vijay
el 17 de Ag. de 2019
Hello Rayane,
The Mambo FPV camera is supported only by the MATLAB Support Package for Parrot Drones (available from R2019a and above). This workflow requires you to have the original Parrot firmware in the drone.
The screenshot shows that you are using Simulink Support Package for Parrot minidrones which overwrites the original firmware with the custom firmware.
Please revert back to the original Parrot firmware by following the steps mentioned in the link below to work with the drone's FPV camera using MATLAB commands.
4 comentarios
Ali Buendia
el 16 de Ag. de 2019
The link below is a circular referece to this page:
"Please revert back to the original Parrot firmware and follow the steps mentioned in the link below to work with the drone's FPV camera using MATLAB commands.
Do you have the link to how to revert the firmware?
Srijith Vijay
el 17 de Ag. de 2019
Hi Ali,
Here is the MATLAB doc link on how to restore the original Parrot firmware:
Edited the link in the answer above. Thanks for pointing out the typo.
-Srijith
Ver también
Categorías
Más información sobre MATLAB Support Package for Parrot Drones en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!