Serial communication with a header and a terminator
14 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I want to send two uint16 numbers through the serial communication. The DSP wants the header and terminator to be equal to 'S' and 'E'. The command serial does not have an option for 'header' but it has an option for defining 'terminator'.
obj=serial(USBport);
obj.BaudRate=9600;
obj.Terminator='E';
obj.ByteOrder='LittleEndian';
To use the header I am writing
fwrite(obj,'S','char')
Now in order to send the two numbers I am using:
x = int16(1);
fwrite(obj,[x x],'int16')
I know that in each fwrite command an 'E' will be sent as well. How can I avoid this? Can I just send E at the end of the commands with another fwrite?
I am using this block to configure the DSP for receiving data.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/223759/image.png)
2 comentarios
Walter Roberson
el 10 de Jun. de 2019
"I know that in each fwrite command an 'E' will be sent as well."
That should not happen. fprintf() can send terminators when you are not expecting them, but fwrite should not send the terminator unless you happen to send one as data.
However, you would want to check to see whether it sends each fwrite() as a separate packet, which could be a problem for USB over serial.
Respuestas (1)
Gayatri Menon
el 4 de En. de 2022
Hi,
Protocol Decoder block and Protocol Encoder block might be useful in such scenarios.
For more info, refer the following links
Hope this helps
Thank you
Regards
Gayatri
0 comentarios
Ver también
Categorías
Más información sobre Get Started with DSP System Toolbox en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!