F28379D DRV8301 current sense problem
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hello,
I´m working on a U/f-Controll for Launchpad F28379D and DRV8301 to test current measurement.
I removed JP1 JP2 JP3 and set JP6. With DRV onboard AD-conversion is working and also host communication.
In the main ISR EN_GATE is set to high. The U/f control works fine and the motor spins.
On the Pins at J3 (IA-FB, IB-FB, IC-FB) I can mesure 1.65 V without an AC-component and therefore the serial monitor receives 2048 from current measurement.
Everything but the current sense is working.
My supspicion is that the gain for current shunt amplifiers is unselected.
I want to send over SPI, but is this the correct way?
constant block (hex2dec('16 bit word`) -> convert(uint16) -> SPI Master Transfer TX
0 comentarios
Respuestas (1)
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!