Thermocouple measurement in Simulink Desktop Real-time using National Instrument devices
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Shubham Yadav
el 19 de Ag. de 2019
Comentada: Danny
el 23 de Feb. de 2024
Hi,
I want to measure temperature using thermocouple . Currently I have NI-9211 module with chasis NI-cDaq-9174 using these I can get temperture in session based interface. Can I use these hardwares in Simulink Desktop real-time to get temperature and perform real time simulation? If not, then which NI device will be needed to take temperature reading using thermocouple.
Thanks a lot.
0 comentarios
Respuesta aceptada
Roshni Garnayak
el 22 de Ag. de 2019
Simulink supports NI 9211 and NI cDAQ-9174 for versions R2016b and above.
To get a list of National Instruments hardware supported by MATLAB and Simulink, refer to the following link:
2 comentarios
Danny
el 23 de Feb. de 2024
That is correct regarding Real time Sync block, did you manage to select K type thermocouple in the Simulink Anolog Input block in Data Acquisition Toolbox Library? I can only find mV measurement on my NI9212.
Más respuestas (0)
Ver también
Categorías
Más información sobre Real-Time Simulation en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!