Infinite for loop getting stuck. Creating a new column containing a variable.
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
nskel
el 26 de Ag. de 2019
Comentada: Andrei Bobrov
el 30 de Ag. de 2019
Hi, I am trying to generate a new column variable within a table which is conditional on 2 other values. The for loop I am using to generate it is getting stuck, however. It is generating the right values for me but just gets stuck and goes through the column over and over again. Any help would be appreciated:
data.signal = zeros(size(data.NAPMPMIIndex));
for indx=1:numel(data.NAPMPMIIndex)
if(data.NAPMPMIIndex(indx) > 50 & data.AboveMA(indx)> 0.5)
data.signal(indx) = 0.5
elseif(data.NAPMPMIIndex(indx) > 50 & data.AboveMA(indx)< 0.5)
data.signal(indx) = -0.5
elseif(data.NAPMPMIIndex(indx) < 50 & data.AboveMA(indx)> 0.5)
data.signal(indx) = 1
else
data.signal(indx) = -1;
end
end
10 comentarios
Adam Danz
el 29 de Ag. de 2019
I ran the code in your question using the data attached to your comment above. The loop is not getting stuck nor is it repeating the same column as you described. The loop runs as it should.
To confirm that, run this version below. The the only differences are
- semicolons are used to suppress unnecessary output.
- a counter "c" is used to count each iteration of the for-loop and the count is displayed so you can visually confirm that the loop has the expected 714 iterations.
load spxpmi2
data.signal = zeros(size(data.NAPMPMIIndex));
c = 0;
for indx=1:714
c = c+1;
disp(c)
if(data.NAPMPMIIndex(indx) > 50 & data.AboveMA(indx)> 0.5)
data.signal(indx) = 0.5;
elseif(data.NAPMPMIIndex(indx) > 50 & data.AboveMA(indx)< 0.5)
data.signal(indx) = -0.5;
elseif(data.NAPMPMIIndex(indx) < 50 & data.AboveMA(indx)> 0.5)
data.signal(indx) = 1;
else
data.signal(indx) = -1;
end
end
Respuesta aceptada
Andrei Bobrov
el 27 de Ag. de 2019
kk = [data.NAPMPMIIndex > 50, data.AboveMA > .5];
g = findgroups(kk(:,1),kk(:,2));
a = [-1;1;-.5;.5];
data.signal = a(g);
3 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Startup and Shutdown en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!