"Parametric Audio Equalizer for STM32 Discovery Boards" errors by pressing the "Monitor & turn" button.
8 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
liangmaokun liangmaokun
el 26 de Dic. de 2020
Comentada: liangmaokun liangmaokun
el 18 de En. de 2021
The errors returned are shown below:
External Mode Open Protocol Connect command failed
Caused by:
DWARF Parser internal error: Parser::describeSymbol xcpDummyDoubleVariable is not a global variable
Component:Simulink | Category:Block diagram error
Unable to connect to the 'STM32F746G-Discovery' target for 'stm32f746gdiscovery_audio_equalizer'.
Component:Simulink | Category:Model error
This project is loaded from "Embedded Coder Support Package for STMicroelectronics Discovery Boards".
If pressing "run" or "Build,Deploy & Start",there is no error returned.
If other modules are commented out and only input and output are left, as shown in the figure, this error message will still be reported. This problem will not appear on the stm32f4 disco development board. Note that stm32f4 uses an additional ttl-233.
2 comentarios
Respuestas (0)
Ver también
Categorías
Más información sobre STMicroelectronics Discovery Boards en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!