Protecting a subsystem in simulink
61 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Ashwini More
el 5 de En. de 2021
Comentada: Joel Van Sickel
el 6 de En. de 2021
I am trying to protect a subsystem block from third party but they should be able to run the simulation without identifying the model. I tried this by referencing the model and then coding but again it is giving error.
Is there anyone can help me with step by step procedure to protect the model?
0 comentarios
Respuesta aceptada
Joel Van Sickel
el 5 de En. de 2021
Hello Ashwini,
please use this page as a reference. If part of it doesn't work, please share the specific error message to get better help.
Regards,
Joel
2 comentarios
Joel Van Sickel
el 6 de En. de 2021
you should be able to replace the old model with the protected model and run the simulation. In that case, you will need to provide the protected model file (the .slxp), and that can be used instead of the original system. The error message makes sense if you were trying to open the protected model, since it wouldn't allow that.
If you have report generator, you can make a read only view: https://www.mathworks.com/help/simulink/slref/protected-models-for-model-reference.html
Regards,
Joel
Más respuestas (0)
Ver también
Categorías
Más información sobre Model Protection en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!