How to give my PI controller initial value?

22 visualizaciones (últimos 30 días)
Adeel Ashraf
Adeel Ashraf el 5 de En. de 2021
Comentada: Jon el 6 de Sept. de 2023
As my system initialize at 1800 RPM. I want to give inital value to my PI controller to remove the swing curve as you can see in my scope result. So that I can reduce the simulation time.
But I don't know how to do it.

Respuestas (1)

Jon
Jon el 5 de En. de 2021
If you want the inital output of your PI controller to be 1800 when the error signal is zero then set the initial value of the integrator to 1800/I where I is the integrator gain
  4 comentarios
Hedi BASBAS
Hedi BASBAS el 6 de Sept. de 2023
Hi Jon,
Could you explain with equations how you choose the inital condition as 1800/K_i ?
Best regards;
Jon
Jon el 6 de Sept. de 2023
For basic PI control the controller output, u is given by u = K_p*e + K_i*E, where e = (y_setpoint - y) and E is the state representing the integrated error. Assume you start your controller with y=y_sestpoint so the error e is zero. Then in order for u = 1800, we have 1800 = K_p*0 + K_i*E. Solving this for E, the initial state of the integrated error, gives E = 1800/K_i

Iniciar sesión para comentar.

Categorías

Más información sobre Simulink en Help Center y File Exchange.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by