ni daq 6008 configuration

i am doing sensor measurement using ni usb 6008 and i made the configuration to be single ended channel the range should be changed to +10 to -10 but that didn't happened , I also connected the same sensor to labview signal xpress on single ended and it works very well , so i think the problem is here in matlab with my code.

    % 
 % get connected devices
 d = daq.getDevices
 %create session 
  s = daq.createSession('ni')
  %add analog channel  s.addAnalogInputChannel('ID',channel num, 'measurement type')
  s.addAnalogInputChannel('Dev1',3, 'Voltage')

    % set rate of scan  4 scans/second ,  run for 3 seconds
 s.Rate=4;
 s.DurationInSeconds=3;

       v= s.Channels(1);
        set(v)
    %_____________________________
     v.TerminalConfig = ' single ended  ';
     v.Coupling = ' DC';

     v
   %start aquisition and plot
    [data,time] = s.startForeground;

   plot(time,data)
    grid on
   xlabel('Time (sec)')
    ylabel('voltage in v')
   s.release()

Answer 1

[mado]

any help with daq