How to connect simulink block and simpowersystem block

5 visualizaciones (últimos 30 días)
Pramit Biswas
Pramit Biswas el 31 de Ag. de 2013
Respondida: zoheir tir el 30 de Ag. de 2021
I want to connect these two blocks. How can I?

Iniciar sesión para responder a esta pregunta.

Respuestas (3)

Azzi Abdelmalek
Azzi Abdelmalek el 31 de Ag. de 2013
Look at this Simulink-PS Converter
  2 comentarios
Pramit Biswas
Pramit Biswas el 31 de Ag. de 2013
i tried but it's not working here unfortunately. :(
Azzi Abdelmalek
Azzi Abdelmalek el 31 de Ag. de 2013
Connect your ramp signal to Simulink-PS Converter. Are the two blocks connected?
After that you should maybe connect the output of your S-PS block to a controled current source or controlled voltage source, then connect the output to your rlc circuit.

Iniciar sesión para comentar.

Azzi Abdelmalek
Azzi Abdelmalek el 1 de Sept. de 2013
In SympowerSystem/Electrical Sources choose a controlled Curent Source or Controlled Voltage Source (Depends on what you need). Connect the Output of your rampe To its first input, Connect the Ground to its second input. Connect its Output to Your Serie RLC Branche
zoheir tir
zoheir tir el 30 de Ag. de 2021
Dear All,
Please find attached a good idea about the connection between the Simulink block with the simpowersystem block.
I used the boost converter as ex.
Regards
Zoheir

Categorías

Más información sobre Power Converters en Help Center y File Exchange.

Etiquetas

Productos

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by