Matlab code asking for too much virtual memory

Hello

So i am running my code on a remote computer in my university. Now the code used to run fine till the university did some upgrades to the computer. After the upgrades when i run the same code, the code stops after a couple of minutes as it is asking for a large amount of virtual memory.

I am working on the 2012b version. When the code stops, it reportes the phys. memory and virtual memory used: resources_used.mem=10919344kb resources_used.vmem=288093536kb

so as you can see it was asking for 288GB of VMEM!!! Does anyone know what might be the problem?

Answer 1

[Walter Roberson]

Have you tried running your code through the profiler and examining memory usage? You could insert something to make the code end early if running is expensive and you wanted to get an idea of what is going on.

[Amir]

Do you know i can check the memory usage through the profiler because i can only see the time used by each in the profiler but no mention about memory usage

Thanks

[Walter Roberson]

http://www.mathworks.com/matlabcentral/newsreader/view_thread/261489