Simple fnc model has error message about || and && operators
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
I get the following error message when I update a model
"Operands to the '||' and && operators must be convertible to logical scalar values."
The fnc is a simple fnc block, that takes two scalar double inputs, u(1) and u(2), and performs a math operation on them and then outputs the result to one outport block. The inputs come from two inport blocks that are followed by a mux.
What does '||' and && have to do with this? Is that part of the mux block, under the hood? If so, is a selector block needed after the mux and before the input to the simple fnc block?
1 comentario
Kaustubha Govind
el 15 de Ag. de 2011
The error looks like it could be coming from your Fcn block. Try executing "dbstop if all error" at the MATLAB prompt before updating your model to see if MATLAB breaks in the function that the error occurs at.
Respuestas (2)
Fangjun Jiang
el 20 de Ag. de 2011
There is a difference between && and &. && applies to scalar and & applies to vector. Try the following one at a time to see the difference. Your input might not be a scalar as you expected.
1.2 && 3.5
[1 2] & [3 4]
[1 2] && [3 4]
0 comentarios
Ver también
Categorías
Más información sobre Event Functions en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!