visadev cannot close connection

6 visualizaciones (últimos 30 días)
Yue Xiao
Yue Xiao el 25 de Mayo de 2022
Editada: chrisw23 el 2 de Mzo. de 2023
I use visadev to connect instrument through LAN. It can connect and send commands, no problems. But when I want to disconnect the instrument, sometimes MATLAB just shows busy. It will take very long time to disconnect. Sometimes I have to close MATLAB. Does anyone have the same issue, or any suggestions? Thanks.
Below it shows when I close the connection, it calls Channel.m and line 177 takes 9 minutes.
  2 comentarios
Akshayaa Pandiyan
Akshayaa Pandiyan el 1 de Mzo. de 2023
How do you disconnect the instrument?
chrisw23
chrisw23 el 2 de Mzo. de 2023
Editada: chrisw23 el 2 de Mzo. de 2023
I recommend to install the vendor specific VISA tools (typically niMax or Keysight ConnectionExpert) and use the IOTrace Tool to monitor communication, when trying to close the instruments session. Probably there's Matlab polling (loop functionality) active and it takes a long time to get the slot to execute your close cmd.
Another point maybe that there are multiple unclosed (older) session objects from debug runs that cause sooner or later communication blocks until Matlab was restarted. So be sure to clear up your object references when debugging will be stopped.
Unfortunately the code provided is not suited to analyze the problem deeper.

Iniciar sesión para comentar.

Iniciar sesión para responder a esta pregunta.

Respuestas (0)

Categorías

Más información sobre Instrument Connection and Communication en Help Center y File Exchange.

Etiquetas

Productos


Versión

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by